Identificador: 2173
Abierta
ID de articulo : # 2181 se ha agregado a su lista de deseos.
Descripción
PARTE: 12477 - COVING BACKSPLASH - EVANS
USADA - BUENAS CONDICIONES
14 feet long x 5 feet deep
208 Volts
Pago y Devoluciones
- Forma de pago
- Visa/Mastercard/American Express, Transferencia/Deposito Bancario
Publicar mensaje
Ingresar to ask the seller a question.
AMXmachinery
SIERRA ESCUADRADORA 3200 MM
PARTE # 2TA-TS-P3200MA - SIERRA ESCUADRADORA - 3200 MM NUEVA CON GARANTIAHeavy duty construction provides vibration free operation. Easy to set up and adjust.Manual raise, lower and tilt of main blade and scoring saw.Scoring unit provides clean, accurate, chip free cutting, ready for edge banding.Sealed main shaft bearings (lubricated for life) with vibration dampening system.Highly accurate, freely moving sliding table with wear resistant guide rails and rollers.Specially designed roller carri...
AMXmachinery
MAQUINA FORJADORA MANUAL
PARTE # 1EF-001 - MAQUINA FORJADORA MANUAL CON MUELAS DE ACERO SPROCKET GOLDEN Maquina forjadora para la elaboración de escoba de fibra de mijo y otras fibrassintéticas y naturales y elaboración de trapeador. Capacidad de produccion: 30 a 35 docenas por turno.
AMXmachinery
SIERRA CINTA – VOLANTES 36” – 20 HP - CON ALIMENTADOR – STENNER
PARTE: 12227 – SIERRA CINTA – VOLANTES 36” – 20 HP - CON
ALIMENTADOR – STENNER
USADA – MUY BUENAS CONDICIONES
Wheel
Diameter: 36"
Max.
Bandsaw Width: 100mm
Maximum
Depth of Cut: 370mm
Saw
Motor: 20 HP, 230/460v, 3ph
Feed
Motor: 0.55 HP, 230/460v, 3ph
Feed
Speeds: 7.5, 15, 22.5, and 30 m/min (Need to Change Belt)
Table Size: 31" x 37"
AMXmachinery
PARTE: 2AM-U-400 - ARMADORA DE MARCOS - SEMIAUTOMATICA
PARTE:
2AM-U-400 - ARMADORA DE MARCOS - SEMIAUTOMATICANUEVA CON GARANTIAThe U-400 has been designed for ease of operation and is particularly well suited for joining large frames up to 5 ½” (140mm) in width.Supplied with a tilting floor stand, the machine can be operated from the front or back and has a single stage pneumatic foot pedal that activates the Horizontal Clamp, securing moulding during the joining process.After the framer sets the two position stops for measuring the max distance...